[Home] [Headlines] [Latest Articles] [Latest Comments] [Post] [Sign-in] [Mail] [Setup] [Help]
Status: Not Logged In; Sign In
|
Science/Tech See other Science/Tech Articles Title: Western Digital Announces High-Capacity 12TB, 14TB Helium-Filled Hard Drives TEHRAN (FNA)- Western Digital was the first company to bring helium-filled hard drives to market, and the company is doubling down on its technology with the introduction of two new drives, with a 12TB drive shipping now and a 14TB coming in the near future. Hard drives may not demand the enthusiast attention they once did, thanks to the vastly improved performance of SSDs. But they still offer much more storage at a lower cost per gigabyte than your typical solid state drive. The 12GB HGST Ultrastar He12 (HGST is a subsidiary of Western Digital) is an eight-platter drive that packs 864Gbits/sq. inch and spins at 7200 RPM. It’s available in both SATA and SAS, with a maximum burst transfer rate of 6Gb/s or 12Gb/s depending on the interface (sustained transfer rate for the drive is identical between the two versions, at 243MiB/s – 255MiB/s). Both drives have a 256MB cache and an 8ms seek time for reads (8.6ms for writes). According to Western Digital, this eight-platter configuration packs in a full two platters above the highest-density air drives. For that, you can thank helium. Because helium is so much less dense than air, drive platters can be packed more tightly and there’s less vibration and friction to contend with inside the drive itself. In theory, Western Digital could use helium drives to spin a smaller number of platters more quickly, but the advent of SSDs has likely put an end to such endeavors. Even if an enterprise hard drive could be spun up to, say, 25,000 RPM (1.66x faster than the fastest 15K drives), it still wouldn’t hold a candle to the seek times or transfer rates on modern solid state storage. There is a difference between the 12TB and upcoming 14TB drives, however, even though both are based on the same eight-platter design and rely on helium: The 12TB drive uses PMR (perpendicular magnetic recording) while the 14TB drive will use SMR (shingled magnetic recording). SMR can reach higher areal densities than PMR because the drive tracks are overlaid on top of one another, as shown in the image below (the image is originally from a Seagate presentation, but the concept applies to all SMR drives). For more on SMR and Seagate’s rollouts, see our coverage here and here. Because there is now an overlap across the tracks, the HDD’s write head will overwrite more than one track at the same time. This requires the drive to read and then rewrite data to multiple tracks at once to avoid erasing vital information, and it slows down overall drive performance. As a result, SMR drives typically aren’t recommended for consumer use — they’re intended for enterprise deployments where their drawbacks are outweighed by the increased storage capabilities they offer. SMR drives can pack up to 25% more data on the same platter as a conventional PMR drive, so it wouldn’t surprise us to see Western Digital roll a 16TB SMR drive at some point in the not-too-distant future. There are two kinds of SMR drives: host-managed and device-managed. Host-managed drives require the operating system and/or applications to manage their idiosyncrasies and ensure that track rewriting is kept to a minimum, while device-managed drives present to the operating system like standard hard drives. The upcoming Ultrastar He12 14TB is a host-managed device, which makes it a poor fit for consumer hardware. Seagate and other companies are expected to introduce their own 12TB drives in 2017, with 16TB drives expected in the next few years (our tea leaves are mum on whether this points to 2018 or 2019-2020 for new drive introductions). Post Comment Private Reply Ignore Thread
|
||
|
[Home]
[Headlines]
[Latest Articles]
[Latest Comments]
[Post]
[Sign-in]
[Mail]
[Setup]
[Help]
|
||